ACCESSORIES LIGHT CONTROL
DMXS4
DMXS4Availability:
A-000000-05906
EAN code: 4052809230269
The “DMXS4” from INVOLIGHT is a splitter and repeater. It offers four 3-pin XLR outputs to split the DMX signal on larger setups and installations. This device receives the incoming DMX signal and distributes it to 4 separate outputs. This reduces problems with ground loops and amplifies the DMX signal. All outputs include 3-pin XLR jacks that are electronically isolated to ensure uninterrupted data flow. 4 green control LEDs indicate that everything is ok and the outputs are ready. In addition, each output has dedicated drivers to amplify the incoming signal.
DMXS6
DMXS6Availability:
A-000000-05907
EAN code: 4052809230276
The “DMXS6” by INVOLIGHT is a professional splitter and repeater for direct truss assembly with Velcro. It offers six 3-pin XLR outputs for dividing the DMX signal in complex setups and installations. This device receives the incoming DMX signal and distributes it to 6 separate outputs. This reduces problems with ground loops and amplifies the DMX signal. All outputs include 3-pin XLR jacks that are electronically isolated to ensure uninterrupted data flow. The switchable 120 Ohm terminator for the DMX Link-Out is also extremely useful. If this is not required, the terminal resistor can be connected to prevent interference. Each output has a red and green control LED. These signals whether everything is OK (green) or a fault (red). In addition, each output has dedicated drivers to amplify the incoming signal.
DMXS8
DMXS8Availability:
A-000000-05908
EAN code: 4052809230283
The “DMXS8″ by INVOLIGHT is a splitter and repeater in 19 ” format. It offers eight 3-pin XLR outputs for dividing the DMX signal in complex setups and installations. This device receives the incoming DMX signal and distributes it to 8 separate outputs. This reduces problems with ground loops and amplifies the DMX signal. All outputs include 3-pin XLR jacks that are electronically isolated to ensure uninterrupted data flow. The switchable 120 Ohm terminator for the DMX Link-Out is also extremely useful. If it is not needed, the end resistor can be connected to prevent interference. Each output has a red and green control LED. These signals whether everything is OK (green) or a fault (red). In addition, each output has dedicated drivers to amplify the incoming signal.